AZURO pH plus CZ

Product detailed description

chemical product for swimming pools and Spa's, AZ pH plus 0,9kg or 4kg, 504pcs on pallet

Powder preparation for increasing the pH value of pool water.
It is used when the pH value is lower than 7.2. Bathing water should have a pH value in the range of 7.0 - 7.4. In this range, the greatest effect of chlorine preparations is given without side effects. The pH value is therefore checked at least 2 times a week and deviations from the ideal value are immediately regulated (mainly a check is necessary before adding chlorine preparations). A pH value over 7.4 can cause milky turbidity in the water (precipitation of calcium), reduced effectiveness of chlorine products, chlorine odor, eye and skin irritation, and can also lead to clogging of the filter device. At pH values ​​below 7.0, there may be increased corrosion of metals and concrete, fading of the colors of the materials from which the pool is made, as well as eye and skin irritation.

Dosage: To increase the pH value by 0.2, add approx. 10 g of the preparation to 1 m3 of water (1,000 l) (a higher dose is usually required for soft water). The calculated amount is thoroughly dissolved in water in a plastic bucket and slowly poured into the pool at the water inlet with the filter device switched on. Measurement of the pH value (with a suitable tester) must be carried out after the water in the pool has been thoroughly mixed. The procedure is repeated until the pH value is in the desired range of 7.0 - 7.4.